My old trailer. I installed gate-hinges into the top a few years ago so that I can remove it easily when required.
But now it's time to make a rear gate. The solid box is great, but not always practical.
...finesse the back away...
Grinder cuts are pretty sloppy...smooth 'em out with the grinding head.
Sometimes we end up with stock returns at work that land into this junk pile. Too good to recycle...machined or damaged beyond sale quality.
So I chopped 'em up to make a rear gate.
Then had lunch. :D
And got back to work a tappin'
And drillin'
And cuttin' a panel
And trimmin' the corners
Cartin' ma' bits off to the work bench
No welding. All tap/bolt joinery.
Like magic, a gate appears fully assembled with a 5mm smoked polycarbonate inset panel. (protective coating still in place)
It fits great.
But needs a gate hinge installed about here...
Shazam. It's done and looks awesome. The entire thing can be lifted off of the hinges easily when required.
This clown came in to work on a Saturday asking about pizza. I sent him on his way....
I installed a gate latch to keep the door closed.
And then discovered that my trailer wasn't built square!!!! The top is ~17mm narrower than the base. Nothing I can do but turn the gate into a trapezoid. Reworking is my worst enemy.
So 2hrs later, I'd cut several 1.5 degree miter cuts to pull the shape in the way I needed and maintained a good edge all around. Nightmarish eyeballing work.
Came up great in the end. :)
